Hello! Welcome to the official website of Maanshan Five Star Blade Mould Co. LTD
簡(jiǎn)體中文
English
Analysis of common faults of line cutting press with ultra-thin round blade
更新時(shí)間：2020-10-22
Analysis of common faults of line cutting machine with ultra-thin Blade
Difficulty in starting or operating the blade
Insufficient voltage; Power supply phase loss; Circuit fuse blown out; The motor is broken; The fixed key of the driving wheel falls off; Transmission gear into a foreign body stuck; Bearing damage or groove gap adjustment is too narrow, the blade is stuck.
2. Automatic stop.
1) power; The frequency conversion current range is not adjusted properly; The driving wheel suddenly falls off; The computer input is wrong.
3. The grinding wheel cannot be lifted or lifted freely.
Insufficient air pressure; (2) Solenoid valve damage; (3) The cylinder that controls the wheel lift is damaged, or the spring that pulls the recovery is loose; The grinding wheel is too tightly attached to the blade, which is improper adjustment of the grinding wheel.
4. Suddenly the machine noise increases and vibrates rhythmically.
The fasteners are loose; Drive gear into the edge of the paper.
